Reset VDR instead of assert when sensor misalignment is detected
Updated the heading process noise logic
Fixed the issue of unintentional COLD start trigger
Fixed the late acquisition by 1 sec due to missing sat aiding
Fix "libgps : proxy__gps_start, CP Cold Start is running, skip gps_start"
Change in scheduling capability to treat less than 1000ms interval as 1000ms
and ignore accuracy mask
Relax the magnitude check of L5 bias to write to NVMEM
Added CpLppeHighAcc3DPosInAgnssProvideLoc (default:false) to combine a_gnss
and lppe ProvideLocationInformation
Change LogJava to retry connection to log service
Aiding B2a from B1I measurement was fixed
Fixed not to make assistance data request for CP
Change to allow IgnoreRomAlm to work.
Change the searching strategies.
Cange to use previous SIM card's IMSI
More adjustment for the LTE filter Bias
Added xml attribute OnDemandTimeCapability
SW change for the altitude
Implemented robustness for position loss after position request restarts
Fix SUPL OTDOA capability issue
Bug: 195607949
Bug: 193609637
Bug: 195489111
Bug: 194752965
Bug: 194728243
Bug: 194633864
Bug: 194309353
Bug: 194133982
Bug: 193477020
Bug: 193374889
Bug: 193114467
Bug: 192630262
Bug: 192047043
Bug: 191340913
Bug: 189412038
Bug: 193476205
Bug: 194974278
Sanity Test: 195599028
Test: build pass
Change-Id: I2d0367eb8e736c7e349609532d04d891cd51621e
- Implemented so that H.264 decoder return FEATURE_NOT_SUPPORTED error
when content is 10-bit.
- Implemented to support dynamic frame rate change for Hierarchical-B
encoder.
- Implemented to support the adaptive GOP feature.
- Fix the MinQuality rate control (20210629 release) bug which encoded
stream is corrupted when Hierarchical-P/B is enabled.
Bug: 194873668
Test: 1 day pretest (ATL0)
Test: DevCam video recording
Test: Hierarchical-B testing
Signed-off-by: ByungGwan Kang <bk0917.kang@samsung.com>
Signed-off-by: wenchangliu <wenchangliu@google.com>
Change-Id: Ic924c0c6479b952c16f5fa4a4a3511f852774aab
MPMM/PPM readings, OFFSRC and PWRONSRC will be printed out.
Bug: 195455000
Test: Local Test and confirm its printed.
------ Instruction ... ------
enable_mitigation=1
mpmm_settings=0x1a
offsrc=0x0
ppm_settings=0x0
pwronsrc=0x4
Signed-off-by: George Lee <geolee@google.com>
Change-Id: I1f3e10edc416966f0eba18e0ba94fb56a487eaee
These are small, usually <1MB. Attaching more CPA traces gives us some
buffer to ensure that the relevant trace is actually included in the bug
report. Previously if the user opens one or two more camera sessions
after they observe the performance issue, the trace will be missing.
Bug: 191169822
Test: Build
Change-Id: I4c10217c39991e80f25a7fd90eee9e8b8c5b6cdb
Remove below Google SUPL certs from gps.cer
- GoogleSuplCertificateEquifax
- GoogleSuplCertificateGeo
- GoogleSuplCertificateGlobalSignR2
- GlobalSign Root R1
Bug: 193865889
Test: basic GNSS function test pass and SUPL NI test pass
Change-Id: I2fee22f0832784d20aa055239ac0d92c0d3a671d
This also change the sequence of run_rawcap_read_all
and run_self_rawcap_read_all to last. Because these
two commands need to run selftest first to read data,
this will make ambient update to make other raw data with
differen baseline.
Bug: 195111369
Test: check touch data in bugreport.
Signed-off-by: Super Liu <supercjliu@google.com>
Change-Id: I4693b099fbc98d80fbe166525773e3ab803c98d8
Enable support for height/width swap so that vertical videos
with supported resolution can be played with HW AV1 decoder.
bug: 195409679
Test: AV1 video playback in vertical as well as horizontal orientation.
Signed-off-by: Vinay Kalia <vinaykalia@google.com>
Change-Id: I939f6a0dc432f6b1c92a1e818647afb66c20d856
Enabling batoilo thermal zone.
Reduced soft_ocp_warn per bug 184739333.
Bug: 194240210
Test: Local test: flash and boot
Signed-off-by: George Lee <geolee@google.com>
Change-Id: I4cad70946af1cd8ffd2131df9f505dac49b8c8f8
Start bootanimation explicitly by name. Let animation start before
surfaceflinger to avoid the condition ctl.start bootanim queued after mount_all command.
Bug: 193726798
Bug: 191910503
Test: boot test
Change-Id: Id0d276ac8bca39c6ac1dae2b2d542107a9522b91
This reverts commit ce6f6da1587615240b7cd2582209c6838cb3bec8.
Reason for revert: Due to b/194243206, TTY shall keep supporting for WCDMA/GSM devcie. Thus revert this CL for pixel 2021 and after.
Bug:194243206
Test: b/194243206#comment22
Change-Id: I650eb50a12bebcd55d04a4ab18bf1d78480a0af5
Use the default chosen by the block layer (64). The purpose of this patch is
to reduce storage latency. Without this patch:
# grep -aH . /sys/block/sd*/queue/nr_requests
/sys/block/sda/queue/nr_requests:256
/sys/block/sdb/queue/nr_requests:64
/sys/block/sdc/queue/nr_requests:64
/sys/block/sdd/queue/nr_requests:64
With this patch applied:
# grep -aH . /sys/block/sd*/queue/nr_requests
/sys/block/sda/queue/nr_requests:64
/sys/block/sdb/queue/nr_requests:64
/sys/block/sdc/queue/nr_requests:64
/sys/block/sdd/queue/nr_requests:64
Bug: 194450129
Test: Built Android images and installed these on an Android phone.
Change-Id: I236874f3791d62a2d5faf0d37a149025639f5c4a
Signed-off-by: Bart Van Assche <bvanassche@acm.org>
Dump state2power table in cooling_device
Bug: 189488358
Test: local test and state2power table can be dumped.
Change-Id: Ifb9a8e41158c5452b2f6e856d30ac97011460298
Signed-off-by: David Chao <davidchao@google.com>
Enable the FP HAL to read from the mfg_data partition chowning to system
Bug: 193549276
Test: sideload cal with valid signature. auth. enroll.
Change-Id: I0897e545dc368782587ae031716012a806d05485
Leaving maxpower at default i.e. 2mA prevents the phone from
charging from SDP ports. Setting this to 900mA. Kernel would
then set the current limit to 500/900mA based on the configured
speed.
Bug: 194722479
Test: Boot to recovery; Through uart cat maxpower;
Signed-off-by: Badhri Jagan Sridharan <badhri@google.com>
Change-Id: I763c70eb5d19f74e6e846155af69c25ca3e91f85
Since we have 8G/12GB ram, increase swap size from 2G to 3G
since 3G swap shows best result.
note: we had used 2G swap for even 4G ram devices.
Bug: 187488125
Signed-off-by: Minchan Kim <minchan@google.com>
Change-Id: Iea8ab1126c378cd02a89c2ef982262431c894487
Bug: 194386750
Test: no Permission denied while accessing the file node
Signed-off-by: Jack Wu <wjack@google.com>
Change-Id: Ia399e59a2f7098147522161d5c7458545febfb77
So devices not supporting CDMA don't include the feature by mistake.
Bug: 194307361
Test: inspect build artifacts - telephony.cdma.xml is included
Change-Id: I0fe3a3624d2cda2b57347402d62e8a16513174e5
Merged-In: I0fe3a3624d2cda2b57347402d62e8a16513174e5
(cherry picked from commit d808d99ce089ca4c7ff4e2abe8ee76b4eeb38a64)
Update usb_pwr_therm2 emul_temp control to allow
vendor.disable.usb.overheat.mitigation.control to disable/enable
usbc-port throttling to prevent device offline during thermal
mitigation test in lab.
Bug: 194252201
Test: setprop vendor.disable.usb.overheat.mitigation.control 0/1 to
check usb_pwr_therm2 temperature reading
Change-Id: Ia522706ce32bee68596b977a3e526f0b951a95ca
high-group is running on CPU 6-7.
mid-group is running on CPU 4-5.
mid-high-gropu is running on CPU 4-7.
Move camera tasks to CPU 4-7 for 1 seconds when AP launch.
Bug: 194271751
Test: GCA
Change-Id: I8e13e9ad0057b8f42f8ed3958bf0c6d58a5a02bc
Set uclamp_min and prefer_idle to sys_group to improve 2nd init
stage boot time performance.
* original
boot_progress_start_avg: 4832.3
* with tuning
boot_progress_start_avg: 4028.75
Bug: 193192017
Test: boot test
Change-Id: I8ebd52fddceadbee22e9a8c75969d52047b2acfc
This will improve the snapshot performance, especially JPEG encode.
Bug: 192067605
Test: Boot, CTS
Change-Id: I9b879d2c462e0a59891d9a36c770484d00b53e6e
Read duration stats expoted by google,usbc_port_cooling_dev and
push suez atom when the uevent is received. The plugged temperature
is queried every time when the USB port is connected. Maximum
temperature during overheat is queried when the uevent is received.
Bug: 193615568
Change-Id: Ib02e14dbdbe1390476e864d351158c1523a5c311
Use:
* boot-user.img for -user builds
* boot.img for -userdebug and -eng builds
Bug: 188095549
Test: make dist (oriole-user)
Test: make dist (oriole-userdebug)
Change-Id: Ic4df227f2b4c261297272f17e6645b7ce1f5d4f3
- Implemented the IDR-frame encoding on H.264 Hierarchical-B
all-layer Open GOP
- Fix the HEVC decoder 161-warning bug which return continuous
161-warning when the stream is only CRA + RASL frame
- Fix the HEVC encoder bug which VPS/SPS/PPS is added at every
frame when I-period is changed
Bug: 192819468
Bug: 193761849
Bug: 193393118
Test: Verify repro step in bugs
Change-Id: I0fd6f7354890c90041a5438b52b7c4baa91a944e
Signed-off-by: Sunyoung Kang <sy0816.kang@samsung.com>
Signed-off-by: wenchangliu <wenchangliu@google.com>
To support USB port overheat protection, we need to launch thermalHAL in
off charging mode.
Bug: 183573049
Test: verified usb port overheat protection in off charging mode with
emul temp
Change-Id: I0b36646d9779c2c1a25f38aafea5ca178bf91be1
Bug: 194157915
Test: bugreport works normally for touch.
Signed-off-by: Super Liu <supercjliu@google.com>
Change-Id: Ice27991a4cac9cca875b55241126bc6f88fb62b6
Add ResetUclampGrp and NoResetUclampGrp taskprofiles to manage vendor
uclamp_fork_set flag.
Bug: 191973176
Test: build and manual test
Change-Id: Ia9c5677c7d5855bb874a714678246ee06c9471bb
